Why Rane’s HAL System RADs & DRs Require Shielded CAT 5e Cables

Shielded CAT5e or better cable for all RAD and DR devices is required solely to satisfy the high-frequency emissions and susceptibility requirements of government (FCC) and commission-based (CE) regulatory agencies. If you use unshielded cable at an installation, you are improperly installing these products, and violating the approved use restrictions in the US and CE countries. Shielded RJ-45 connector

Continue reading

Georgia HAL Install – Moving the DR & RAD Locations Around

Or Hadash SanctuaryAri Newman at Shade Tree AV in Atlanta, Georgia, installed a HAL System in the Congregation Or Hadash in Sandy Springs, GA. Architectural firm BLDGS brought Shade Tree AV into the project to design a system that complemented the venue’s contemporary design.
The client wanted an audio system that could accommodate many different use scenarios, and the preset capabilities in HAL were the perfect choice. Continue reading

Rack Mounting Rane DR and RAD Devices

Often, Rane’s Decora Remote controls for HAL (e.g., DR1, DR2 or DR3 remotes and many RAD models) need to be placed in the rack room.

To mount them, get a hold of Lowell’s 19″ Punched Rack Panels – specifically, get the D9P-ID-3 model. This is a 3U panel that has nine holes for Decora devices.

NOTE: the D8P-ID-3 model does not work for any of Rane’s two-gang (or more) models. The spacing between the eight holes is not correct. Get the nine-position model.

The 9 position version offers the proper spacing for 2-gang or more DRs and RADs.

The nine- position version provides the proper spacing for 2-gang or more DRs and RADs.

To fill in the empty and unused holes, Lowell offers the DBB-4 pack of four blanks.

Blanks cover unused panel holes

Lowell’s DBB-4 blanks cover unused panel holes

For those craftsmen building custom Decora panels, here’s a drawing with dimensions:

Decora plate dimensions

Decora plate dimensions